Installation Instruction
1.
Loop the cable around any convenient, immovable object such as
the leg of table or
desk, handle of drawer……as shown. Adhere the
adaptor on where your lock is (Fig. 1)
是否要標示墊片
將背膠墊片貼在
要上鎖的物體上,
並將鋼繩如附圖的繞過一固定物體如桌腳,
抽屜門把….等
2.
At the factory code 0-0-0-0 or new set code.
出廠號碼設定為0-0-0-0
3.
Tooth wheel at bottom. Insert the lock into the square hole (Fig.
2)
轉動齒輪到頂,
尾端插入方形孔
4.
Turn the tooth wheel from bottom toward up to open the two legs
stop in square hole.
(Fig. 3)
轉動齒輪向錢到底,
使兩隻腳張開,
並卡在孔內
5.
Turn the combination wheels to lock (Fig. 4). If failure it’s
because not do right at
Step
3 or 4, please do according instruction again.
轉動字輪成亂碼,
此時為上鎖狀態
(若是失敗即尚未確實依據步驟3,4運作,
請重新確實重複3,4的動作)
How to set the combination
1.
All locks were preset at the factory with code 0-0-0-0.
出廠號碼設定為0-0-0-0
2.
To set new code to your preference, in locked position, simply
push the cable
inward the lock and hold while turning combination wheels to desired
code.
在上鎖時,
將鋼繩向鎖頭插入並維持此狀態,
同時轉動字輪至所欲設定號碼
3.
Release the cable, memorize your own personal code or record the
code at a separate location.
鬆開鋼繩,
此時完成密碼的重新設定 |